![]() To conceal it, you can cover the area with a nice area rug or cover it with a piece of furniture depending on the location of the tear. You will just need a steam iron (or a regular iron in a pinch) and some iron-on tape. The heat-activated glue adheres to the tape strongly between the two pieces and makes it look natural. The iron-on tape we mentioned earlier is great for putting two carpets together seamlessly. Related Questions How do I join two carpets together? Along with extra supplies, your total cost would be about $50. But if you opt to do the binding yourself, you can get a caret binding kit for about $20. Therefore a 5×7 rug might cost between $27 and $96, while a 10×10 room could cost between $40 and $160. Professional carpet binding can cost about $1 to $4 per linear foot. Alternatively, there are professionals who do carpet binding, but this will be a lot more expensive than doing it yourself. If applied correctly, this tape should last for at least several years. Take your time here, to make sure you cover the entire area and it’s stuck together nicely.Īnd that’s it. The amount of glue used should be enough to stick, but not so much that the glue sticks out. It’s important to only do small sections since hot glue dries quickly. Run a thin line of glue along the edge of the carpet in a small section and press the binding against it until it dries. Get your glue gun and dab a little between the two ends and hold it for a few seconds until they are dry. When you reach the point where you started, cut the end of the binding tape to fit flush against the starting spot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |